PHILIPS SH71/50 replacement shaving heads for Series 7000 & 5000 - 3-pack, precision steel blades

PHILIPS SH71/50 replacement shaving heads restore close, consistent performance for compatible Series 7000 and angular Series 5000 shavers with a simple swap.

When your shaver starts tugging or takes longer to finish a shave, worn cutting heads are usually the cause. This three-piece SH71/50 set is engineered to match the original Philips geometry and cutting speed so your S7XXX or angular S5XXX shaver performs like new again. Designed as a direct replacement for older part codes (RQ12/70, RQ12/60, SH60/70, SH70/70), these heads help recover cutting efficiency after the typical two-year lifetime of active use.

How do these replacement heads improve shaving performance?

Worn blades and foils reduce contact and cutting efficiency. Installing fresh SH71/50 heads restores the intended blade-to-skin geometry and the sharpness required for efficient passes.

• Up to 90,000 cutting actions per minute for more hairs cut per stroke
• Precision steel blades for uniform cutting edge
• Replacement returns the shaver to near-original performance

Which shavers are compatible with the SH71/50 heads?

These heads are built for Philips Series 7000 models (S7XXX) and angular-shaped Series 5000 models (S55XX). They are also cross-referenced to several legacy part numbers for easy identification.

• Fits S7XXX series shavers from the 7000 lineup
• Works with angular S5XXX (5000 series) models
• Replaces RQ12/70, RQ12/60, SH60/70, SH70/70 head assemblies

How often should I change the shaving heads and how easy is replacement?

Philips recommends replacing heads approximately every two years under typical usage to keep cutting performance consistent. The SH71/50 set is supplied as three heads and can be swapped in minutes without tools.

• Replace heads roughly every 24 months for best results
• Tool-free removal and installation — follow shaver model instructions
• Reset the shaver’s head-change indicator after installing new heads, if applicable

What will I notice after installing the new heads?

Expect smoother passes, fewer re-runs over the same area, and a finish closer to what the shaver delivered when it was new. Fresh heads maintain cutting force and reduce skin tugging caused by dull edges.

• Smoother shave with fewer strokes required
• Reduced pulling or snagging on longer stubble
• Consistent contact across the shaving surface for even results

Who is this for: The PHILIPS SH71/50 3-pack is ideal for men who already own a compatible Philips Series 7000 or angular Series 5000 shaver and want to restore factory-level cutting performance without replacing the entire device. It suits daily shavers and those who use their shaver frequently enough that blades and foils reach the end of their effective life within roughly two years. Choose this set if you want an OEM-quality replacement that’s matched to Philips’ original engineering, straightforward to install, and cross-referenced to older part numbers for easy compatibility checks.